1st step on this journey.. ring your insurance company and make sure your all paid up.the scuttle on this car is a 3 peice affair made if carbon fibre, there are 12 bolts that need to be removed and 2 screws to free it , you then need to remove the gas bonnet struts and their locator nuts ,then while someone is lifting the bonnet you gently wiggle the corner sections out ( ie pain in the arse) then the crntre section comes out. the external pillar moulds are urethaned down and must be replaced ,lift the trim at the top and gently cut it away from the urethane which is locating it ,(they may snap ) the rear vision mirror has a 2 peice shroud over it and the rain sensor remove the bottom section by pulling it towards the bottom of the screen ,the top peice is triangular an just unclips ,then push the murror down to unclip it . the screen is held in by a very wide band of urethane and even with a btb it is hard work . all up scary cost ,the pillar moulds are $880.00 each and the glass is $4850.00