this windscreen is similar to the vw jetta ,(no moulding around the screen ) the only problem is that the clearences between the glass and body are insanely close , in fact due to a mis alignment problem ,too close to even get a braided wire in between the body and glass ,the only  technique that seemed to work was i took the pillar trims off (just pull out but not to violently as there is a speaker in there and you must un-plug it )and do an inside cut with a btd  short blade ( even doing this i touched the body so i masked a straight line along the piller and put a run of sika 205 body primer along it , fortunatly after fitting the new screen even if you looked closely you could not see where i put the primer . hope this helps